Blood × Carpet
How to remove blood stains from carpet
This guide is for Carpet. It does not create separate pages for fresh, dried or set-in states.
Blot or lift the blood first, then use the smallest amount of a cleaner labelled for carpet. Keep the surface rule in view: Use a clean white cloth and keep the carpet only as wet as the method requires. Blot rather than rub, and follow the carpet maker's care instructions.
Keep it simple.
- white paper towels
- white cloth
- carpet-safe product
- cool water
- clean white cloth
- compatible detergent or enzyme product where the label permits
Act before it dries.
- Use cool water and blot or rinse the stain, following the surface rule. Use a clean white cloth and keep the carpet only as wet as the method requires. Blot rather than rub, and follow the carpet maker's care instructions.
- For washable fabric, pre-treat and launder according to the care label. Use a clean white cloth and keep the carpet only as wet as the method requires. Blot rather than rub, and follow the carpet maker's care instructions.
- Rinse or blot away residue and dry only after checking the mark. Use a clean white cloth and keep the carpet only as wet as the method requires. Blot rather than rub, and follow the carpet maker's care instructions.
Use less, check more.
- Loosen the mark with water appropriate to the surface. Use a clean white cloth and keep the carpet only as wet as the method requires. Blot rather than rub, and follow the carpet maker's care instructions.
- On washable fabric, use an enzyme-containing product if the label and care label allow it. Use a clean white cloth and keep the carpet only as wet as the method requires. Blot rather than rub, and follow the carpet maker's care instructions.
- Repeat the treatment before using heat. Use a clean white cloth and keep the carpet only as wet as the method requires. Blot rather than rub, and follow the carpet maker's care instructions.
Work in this order.
- 01
Read the material or care label and test the method in an inconspicuous spot.
- 02
Remove excess blood by blotting or lifting; do not spread it.
- 03
Apply only the carpet-compatible product or detergent called for by the source and label.
- 04
Rinse or blot away residue when the label or surface method calls for it, then dry fully and inspect.
- hot water on fabric, which can set blood
- drying before the mark is gone
- bleach or disinfectant unless the surface/product label allows it
- over-wetting the backing
- hard scrubbing that distorts the pile
- unlabelled solvents on wool, delicate or unknown fibers
- Use one cleaning product at a time. Never mix bleach or any disinfectant with another cleaner.
- Ventilate and use gloves or eye protection when the product label calls for them.
- If the finish, color, backing or odor changes, stop and use the maker or a professional cleaner.
If the blood remains after one labelled treatment, do not escalate to a stronger household chemical by guesswork. Check the care guide for carpet or use a professional service.
Why this guide says that.
Blood guidance was checked against the cited source and narrowed to the Carpet scope. Chemical combinations not required by the source were intentionally omitted.